Adding A Mantel To A Stone Fireplace – Step 2 drill fireplace holes. Step 3 drill mantel holes. Since the mantel has a light and neutral color it allows the fireplace to stand out. Step 1 construction of the mantel. How to add a mantel to your stone fireplace. Now attach the short 2 4 pieces to the 2 4 on the stone with 2 1 2 pocket hole screws and wood glue..
Drive in 2 1 2 screws to secure the 2×4 image 2.
Adding a mantel to a stone fireplace. Make sure those marks are level centered and extend far enough to cover the mantel s length. Don t forget to use a leveler and get it nice and level. Insert the rebar into the hole on the stone and hold in place to allow liquid nail to grab rod 5.
Step 1 decide exact location. Put one on each end and the other two splitting center. The mantel is made entirely of stone.
The existing mantel appears to be recessed into the stone. Most mantels are placed about 60 above the floor. Place marks on the grout line every 16.
Drill a hole in the stone fireplace using a mason drill bit 2. Cut a 1×8 to length and add wood glue to the ends. Create the new mantel clamp a 2×4 to the existing mantel and pre drill holes through both pieces of wood image 1.
If you want you can put accessories on either side of the fireplace though it isn t a must. How to attach a wood mantel to a stone fireplace. Wood mantel on a stone wall supplies.
Step 2 add molding. If so remove it first and then remove enough stone below to accommodate the new mantel. Allow to dry for 48 hours before hanging mantel.
It s important to remember that the top of the mantle will be resting on top of your 2 4 and will be hanging down about another 5 inches. Using the plywood with the finished side out cut a piece approximately 42 inches wide by at least 8 to 10. Mark the grout line that is closest to the desired height.
This kind of fireplace mantel is worth considering if you want a modern and clean looking fireplace. This will give you a more finished original appearance. Step 3 apply finish to mantel.
1 2 x 6 x 8 pine board for the ledger 2 1 x 10 x 8 pine boards top and bottom of mantel 1 1 x 6 x 6 pine board middle supports. Fuz it liquid nails you can purchase on amazon affiliate link. It s time to hang the mantel now.
Consult your local building codes for any specifications for installing a fireplace mantel. Fill hole with fuz it liquid nail 4. Then have the stone cut and laid back to the new mantel.
We first held up the 4 5 foot long 2 4 against the fireplace and drew a line with a pencil of where we wanted it to go. Cut the rebar to size 3.
Adding A Mantel To A Stone Fireplace – Cut the rebar to size 3. We first held up the 4 5 foot long 2 4 against the fireplace and drew a line with a pencil of where we wanted it to go. Then have the stone cut and laid back to the new mantel. Fill hole with fuz it liquid nail 4. Consult your local building codes for any specifications for installing a fireplace mantel. It s time to hang the mantel now..